This is to setup the panel on the rack mount UCTRONICS raspberry pi holder with SSD drives

You will need to get the following from GitHub

sudo git clone https://github.com/UCTRONICS/SKU_RM0004.git

Compile the download

cd SKU_RM0004 sudo make clean && sudo make 

Run this to auto configure

sudo ./deployment_service.sh 

Reboot your Pi

sudo reboot

Below Depricated

You will have to modify the following file

sudo nano /boot/config.txt or sudo nano /boot/firmware/config.txt

At the end of the file add below the last [ALL] section

dtparam=i2c_arm=on,i2c_arm_baudrate=400000 dtoverlay=gpio-shutdown,gpio_pin=4,active_low=1,gpio_pull=up

You will need to get the following from GitHub

git clone https://github.com/UCTRONICS/SKU_RM0004.git

Run the following

cd SKU_RM0004 make

Edit the following file: 

sudo nano /etc/rc.local

You will need to add the following after the fi and before the exit 0

Once modified should look like this

Run the following:

cd /home/pi/SKU_RM0004 make clean make ./display &